Configuration manual

Appendix H Command Interpreter 279
Nortel Business Secure Router 222 Configuration — Advanced
pwderrtm [minute]
Sets or displays the password error
blocking timeout value.
upnp
active [0:no/1:yes]
Activates or deactivates the saved
UPnP settings.
config [0:deny/1:permit]
Allows users to make configuration
changes through UPnP.
display
Displays UPnP information
firewall [0:deny/1:pass]
Allows UPnP to pass through the
firewall.
load
Saves UPnP information.
reserve [0:deny/1:permit]
save
Saves UPnP information.
socket
Displays the system socket’s ID #,
type, control block address (PCB), IP
address and port number of peer
device connected to the socket
(Remote Socket) and task control block
(Owner).
filter
netbios
disp
Displays the current NetBIOS filter
modes.
config <0:Between LAN and
WAN/ 3: IPSec Pass through/
4: Trigger Dial> <on|off>
Sets NetBIOS filters.
roadrunner
debug <level>
Enables or disables Road Runner
service.
0: disable (default)1: enable
display <iface name>
Displays Road Runner information
iface-name: enif0, wanif0
restart <iface name>
Restarts Road Runner.
ddns
debug <level>
Enables or disables DDNS service.
display <iface name>
Displays DDNS information.
Table 69 Sys commands
Command Description