Configuration manual

313
Nortel Business Secure Router 222 Configuration — Advanced
Appendix J
Boot Commands
The BootModule AT commands execute from within the router’s bootup
software, when debug mode is selected before the main router firmware is started.
After you start up your Business Secure Router, you are given a choice to go into
debug mode by pressing a key at the prompt shown in screen shown in
Figure 164. In debug mode you have access to a series of boot module commands,
for example ATUR (for uploading firmware) and ATLC (for uploading the
configuration file). These are already discussed in Chapter 15, “Firmware and
configuration file maintenance” on page 179.
Figure 164 Option to Enter Debug Mode
Enter ATHE to view all available Business Secure Router boot module
commands, as shown in Figure 165. With ATBAx, you can change the console
port speed. The x denotes the number preceding the colon to give the console port
speed following the colon in the list of numbers that follows; for example ATBA3
will give a console port speed of 9.6 Kb/s. ATSE displays the seed that is used to
generate a password to turn on the debug flag in the firmware. The ATSH
Bootbase Version: V1.02 | 08/08/2001 15:40:50
RAM: Size = 16384 Kbytes
DRAM Post: Testing: 16384K OK
FLASH: Intel 16M
RAS Version: V3.50(WB.0)b3 | 08/08/2001 16:21:27
Press any key to enter debug mode within 3 seconds.
.................................................