Configuration manual

54 Chapter 3 WAN and Dial Backup Setup
NN47922-501
Figure 9 Menu 2
Table 6 describes the MAC address fields in Figure 9. See Table 7 for
descriptions of the dial-backup fields.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Dial-Backup:
Active= No
Port Speed= 115200
AT Command String:
Init= at&fs0=0
Edit Advanced Setup= No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Table 6 MAC address cloning in WAN setup
Field Description Example
MAC Address
Assigned By Press [SPACE BAR] and then [ENTER] to choose one
of two methods to assign a MAC Address. Choose
Factory Default to select the factory-assigned default
MAC Address. Choose IP address attached on LAN
to use the MAC Address of that workstation whose IP
you give in the following field.
IP address
attached on
LAN
IP Address This field is applicable only if you choose the IP
address attached on LAN method in the Assigned
By field. Enter the IP address of the computer on the
LAN whose MAC you are cloning.
192.168.1.35
After you complete this menu, press [ENTER] at the
prompt “Press ENTER to Confirm…” to save your
configuration, or press [ESC] at any time to cancel.