Configuration manual

Chapter 3 WAN and Dial Backup Setup 59
Nortel Business Secure Router 222 Configuration — Advanced
Remote node profile (Backup ISP)
Enter 2 in Menu 11 Remote Node Setup to open Menu 11.2 Remote Node
Profile (Backup ISP) (Figure 12) and configure the setup for your Dial Backup
port connection. This feature is not available on all models.
Speed Enter the keyword preceding the connection speed.
CONNECT
Call Control
Dial Timeout (sec) Enter a number of seconds for the Business Secure
Router to keep trying to set up an outgoing call
before timing out (stopping). The Business Secure
Router times out and stops if it cannot set up an
outgoing call within the timeout value.
60
seconds
Retry Count Enter a number of times for the Business Secure
Router to retry a busy or no-answer phone number
before blacklisting the number.
0 to
disable
the
blacklist
control
Retry Interval (sec) Enter a number of seconds for the Business Secure
Router to wait before trying another call after a call
has failed. This applies before a phone number is
blacklisted.
Drop Timeout (sec) Enter a number of seconds for the Business Secure
Router to wait before dropping the DTR signal if it
does not receive a positive disconnect confirmation.
20
seconds
Call Back Delay (sec) Enter a number of seconds for the Business Secure
Router to wait between dropping a callback request
call and dialing the corresponding callback call.
15
seconds
Table 8 Advanced WAN port setup: AT commands fields
Field Description Default