Configuration manual

62 Chapter 3 WAN and Dial Backup Setup
NN47922-501
Editing PPP options
The Business Secure Router dial back-up feature uses PPP. To edit the remote
node PPP options, move the cursor to the [Edit PPP Options] field in Menu 11.2
- Remote Node Profile, and use the space bar to select [Yes]. Press [Enter] to
open Menu 11.2.1 as shown in Figure 13.
Schedules You can apply up to four schedule sets here. For more
details, refer to Chapter 18, “Call scheduling,” on page
213.
1,3,5
Nailed-Up
Connection
Press [SPACE BAR] to select Yes to set this connection
to always be on, regardless of whether or not there is
any traffic. Select No to have this connection act as a
dial-up connection.
No
(default)
Session Options
Edit Filter sets This field leads to another “hidden” menu. Use
[SPACE BAR] to select Yes and press [ENTER] to open
menu 11.2.4 to edit the filter sets. See “Remote node
filter” on page 69 for more details.
No
(default)
Idle Timeout Enter the number of seconds of idle time (when there is
no traffic from the Business Secure Router to the remote
node) that can elapse before the Business Secure
Router automatically disconnects the PPP connection.
This option only applies when the Business Secure
Router initiates the call.
100
seconds
(default)
After you configure this menu, press [ENTER] at the
message “Press ENTER to Confirm...” to save your
configuration, or press [ESC] at any time to cancel.
Table 9 Fields in menu 11.2 remote node profile (Backup ISP)
Field Description Example