Configuration manual

64 Chapter 3 WAN and Dial Backup Setup
NN47922-501
Figure 14 Menu 11.2.2: remote node network layer options
Table 11 describes the fields in Figure 14.
Menu 11.2.2 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= None
Metric= 15
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Table 11 Remote node network layer options menu fields
Field Description Example
IP Address
Assignment
If your ISP did not assign you an explicit IP address, press
[SPACE BAR] and then [ENTER] to select Dynamic;
otherwise select Static and enter the IP address & subnet
mask in the following fields.
Dynamic
(default)
Rem IP
Address
Leave this field set to 0.0.0.0 to have the ISP or other
remote router dynamically (automatically) send its IP
address if you do not know it. Enter the remote gateway’s
IP address here if you know it (static).
0.0.0.0
(default)
Rem Subnet
Mask
Leave this field set to 0.0.0.0 to have the ISP or other
remote router dynamically send its subnet mask if you do
not know it. Enter the remote gateway’s subnet mask here
if you know it (static).
0.0.0.0
(default)
My WAN Addr Leave the field set to 0.0.0.0 to have the ISP or other
remote router dynamically (automatically) assign your
WAN IP address if you do not know it. Enter your WAN IP
address here if you know it (static).
This is the address assigned to your local Business
Secure Router, not the remote router.
0.0.0.0
(default)