Configuration manual

ManualsBrandsAvaya ManualsBusiness Secure RouterAvaya Business Secure Router 222 Configuration - Advanced

88 Chapter 6 Remote Node setup

NN47922-501

PPPoE Encapsulation

The Business Secure Router supports PPPoE (Point-to-Point Protocol over

Ethernet). You can only use PPPoE encapsulation when you are using the

Business Secure Router with a DSL modem as the WAN device. If you change

the Encapsulation to PPPoE, you then see Figure 27. Please see Appendix E,

“PPPoE,” on page 253 for more information about PPPoE.

Service Name If you are using PPPoE encapsulation, then type the

name of your PPPoE service here. Only valid with

PPPoE encapsulation.

poellc

Outgoing

My Login

This field is applicable for PPPoE encapsulation only.

Enter the logon name assigned by your ISP when the

Business Secure Router calls this remote node. Some

ISPs append this field to the Service Name field above

(e.g., jim@poellc) to access the PPPoE server.

jim

My Password Enter the password assigned by your ISP when the

Business Secure Router calls this remote node. Valid for

PPPoE encapsulation only.

*****

Retype to

Confirm

Type your password again to make sure that you have

entered it correctly.

*****

Server IP This field is valid only when Road Runner is selected in

the Service Type field. The Business Secure Router

finds the Road Runner Server IP automatically if this field

is left blank. If it does not, then you must enter the

authentication server IP address here.

Route This field refers to the protocol that is routed by your

Business Secure Router.

Edit IP This field leads to a “hidden” menu. Press [SPACE BAR]

to select Yes and press [ENTER] to go to Menu 11.1.2 -

Remote Node Network Layer Options.

(default)

Session Options

Edit Filter sets

This field leads to another “hidden” menu. Use

[SPACE BAR] to select Yes and press [ENTER] to open

menu 11.1.4 to edit the filter sets. See “Remote Node

filter” on page 95 for more details.

(default)

After you configure this menu, press [ENTER] at the

message “Press ENTER to Confirm...” to save your

configuration, or press [ESC] at any time to cancel.

Table 19 Fields in menu 11.1

Field Description Example