Configuration manual

Chapter 6 Remote Node setup 91
Nortel Business Secure Router 222 Configuration — Advanced
PPTP Encapsulation
If you change the Encapsulation to PPTP in menu 11.1, then you will see the next
screen. See Appendix F, “PPTP,” on page 257 for information about PPTP.
Figure 28 Menu 11.1: Remote Node Profile for PPTP Encapsulation
Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe Route= IP
Active= Yes
Encapsulation= PPTP Edit IP= No
Service Type= Standard Telco Option:
Service Name= N/A Allocated Budget(min)= 0
Outgoing: Period(hr)= 0
My Login= Schedules=
My Password= ******** Nailed-Up Connection= No
Retype to Confirm= ********
Authen= CHAP/PAP
PPTP: Session Options:
My IP Addr= Edit Filter Sets= No
My IP Mask= Idle Timeout(sec)= 100
Server IP Addr=
Connection ID/Name= Edit Traffic Redirect= No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Table 21 shows how to configure fields in menu 11.1 not previously discussed.
Table 21 Fields in Menu 11.1 (PPTP Encapsulation)
Field Description Example
Encapsulation Press [SPACE BAR] and then [ENTER] to select
PPTP. You must also go to menu 11.1.2 to check
the IP Address setting after you select the
encapsulation method.
PPTP
My IP Addr Enter the IP address of the WAN Ethernet port. 10.0.0.140
My IP Mask Enter the subnet mask of the WAN Ethernet port. 255.255.255.0
My Server IP Addr Enter the IP address of the ANT modem. 10.0.0.138