Configuration manual

270 Appendix G Command Interpreter
NN47923-501
urlblocked [0:none/1:log/
2:alert/3:both]
Records and/or sends alerts for web
access blocked logs.
urlforward [0:none/1:log]
Records web access forward logs.
clear
Clears the log.
display [access|attack|error|ike|i
psec|javablocked|mten|pack
etfilter|pki|
tcpreset|tls|upnp|urlblock
ed|urlforward]
Displays all logs or specifies a category
of logs.
errlog
clear
Clears the error log.
disp
Displays the error log.
online
Turns the error log online display on or
off.
load
Loads the log settings buffer. Use this
command before you configure the log
settings. Use sys logs save after
you configure the log settings.
mail
alertAddr [mail address]
Sends alerts to this e-mail address.
clearLog [0:no/1:yes]
Enables the switch to clear the log after
sending logs via e-mail.
display
Displays the logs and alerts mail
settings.
logAddr [mail address]
Sends logs to this e-mail address.
schedule display
Displays the mail schedule.
schedule hour [0-23]
Sets the hour to send logs.
schedule minute [0-59]
Sets the minute to send the logs.
schedule policy [0:full/
1:hourly/2:daily/3:weekly/
4:none]
Sets the mail schedule policy.
schedule week [0:sun/1:mon/
2:tue/3:wed/4:thu/5:fri/
6:sat]
Sets the day of the week to send
weekly logs.
server [domainName/IP]
Sets the domain name or IP address of
the mail server to which the logs are
sent.
Table 64 Sys commands
Command Description