Configuration manual

274 Appendix G Command Interpreter
NN47923-501
parse [[start_idx], end_idx]
Displays detailed packet details of the
packet range specified.
brief
Displays a brief listing of packet
contents.
version
Displays the RAS code and driver
versions.
view <filename>
Displays the specified text file.
wdog
switch [on|off]
Turns the watchdog firmware
protection feature on or off.
cnt [value]
Sets (0-34 463) or displays the current
watchdog count (in 1.6 sec units).
romreset
Restores the factory default
configuration file.
server
Use these commands to configure
remote server management.
access
<telnet|ftp|web|icmp|snmp|
dns> <value>
Sets the server access type.
load
Loads server information.
disp
Displays server information.
port <telnet|ftp|web|snmp>
<port>
Sets the server port.
save
Saves server information.
secureip <telnet|ftp|
web|icmp|snmp|dns> <ip>
Sets server secure IP address.
pwderrtm [minute]
Sets or displays the password error
blocking timeout value.
upnp
active [0:no/1:yes]
Activates or deactivates the saved
UPnP settings.
config [0:deny/1:permit]
Allows users to make configuration
changes through UPnP.
display
Displays UPnP information
firewall [0:deny/1:pass]
Allows UPnP to pass through the
firewall.
Table 64 Sys commands
Command Description