Configuration manual

276 Appendix G Command Interpreter
NN47923-501
Exit Command
Ethernet Commands
Table 66 lists and describes the Ethernet commands. Each of these commands
must be preceded by
ether. For example, type ether config to display
information on the LAN configuration.
Table 65 Exit Command
Command Description
exit
Ends the command interpreter session.
Table 66 Ether Commands
Command Description
config
Displays LAN configuration information.
driver
cnt
disp <name>
Displays the Ethernet driver counters.
status <ch_name>
Shows the LAN status.
version
Displays the Ethernet device type.
edit
load <1:LAN>
Loads Ethernet (1:LAN) data from the System
Parameters Table.
mtu <value>
Sets the Ethernet data Maximum Transmission
Unit.
accessblock <0:disable 1:enable>
Blocks Internet access.
speed <auto|10/half|10/
full|100/half|100/
full>
Sets the Ethernet data speed and duplex.
save
Saves Ethernet data to the System Parameters
Table.
dynamic
Port
dump
Displays the relationship between physical port
and channel.