Configuration manual

Appendix G Command Interpreter 279
Nortel Business Secure Router 252 Configuration — Advanced
status
Displays IP statistic counters.
udp
status
Displays the UDP status.
rip
These are the Routing Information Protocol
commands.
accept <gateway>
Drops an entry from the RIP refuse list.
activate
Enables RIP.
merge [on|off]
Sets the RIP merge flag.
refuse <gateway>
Adds an entry to the RIP refuse list.
request <addr> [port]
Sends a RIP request to the specified address
and port.
reverse [on|off]
RIP Poisoned Reverse.
status
Displays RIP statistic counters.
trace
Enables the RIP debug trace.
mode
<iface> in [mode]
Sets the Business Secure Router to use the
RIP information it receives.
<iface> out
[mode]
Sets the Business Secure Router to broadcast
its routing table.
dialin_user [show|in|out|both
|none]
Shows the dial-in user RIP direction.
tcp status
Displays the TCP statistic counters.
telnet <host> [port]
Creates a Telnet connection to the specified
host.
tftp
support
Displays whether or not TFTP is supported.
stats
Displays the TFTP statistics.
traceroute <host> [ttl]
[wait] [queries]
Sends ICMP packets to trace the route of a
remote host.
xparent join <iface1>
[<iface2>]
Add iface2 to the iface1’s group.
break <iface>
Remove the specified interface from the
ipxparent group.
urlfilter
Table 67 IP commands
Command Description