Configuration manual

Appendix G Command Interpreter 281
Nortel Business Secure Router 252 Configuration — Advanced
timeout <timeout>
Sets the number of seconds the device waits
for a response from the target.
checktime <period>
Sets the number of seconds the device waits
between attempts to connect to the target.
active <on|off>
Enables or disables traffic redirect.
save
Saves traffic redirect configuration.
disp
Displays the traffic redirect configuration.
debug <value>
Sets the traffic redirect debug value.
rpt
active [1:yes|0:no]
Enables or disables the reports.
start
Starts recording reports data.
stop
Stops recording reports data.
url
Records the most visited Web sites.
ip
Records the LAN IP addresses that sent and
received the most traffic.
srv
Records the most heavily used protocols or
service ports.
stroute
display [rule # | buf]
Displays the list of static routes or detailed
information on a specified rule.
load <rule #>
Loads the specified static route rule into the
buffer.
save
Saves a rule from the buffer to the System
Parameters Table.
config
name <site name>
Sets the name for a static route.
destination <dest
addr>[/<bits>]
<gateway>
[<metric>]
Sets a static route’s destination IP address
and gateway.
mask <IP subnet
mask>
Sets a static route’s subnet mask.
gateway <IP
address>
Sets a static route’s gateway IP address.
metric <metric #>
Sets a static route’s metric number.
Table 67 IP commands
Command Description