Configuration manual

Appendix G Command Interpreter 283
Nortel Business Secure Router 252 Configuration — Advanced
IPSec commands
Table 68 lists and describes the IP Sec commands. Each of these commands must
be preceded by
ipsec. For example, type ipsec display 3 to display the third
IPSec rule, if you have it configured.
enable <ALG_FTP|ALG_H323
|ALG_SIP>
Turns on the ALG.
disable <ALG_FTP|ALG_H323
|ALG_SIP>
Turns off the ALG.
Table 68 IPSec commands
Command Description
debug type <0:Disable |
1:Original
on|off | 2:IKE
on|off | 3:
IPSec
[SPI]|on|off |
4:XAUTHon|off |
5:CERT on|off |
6: All>
Turns the trace for IPsec debug
information on or off.
level <0:None |
1:User | 2:Low
| 3:High>
Sets the debug level. The higher the
number, the more detailed.
display
Shows debugging information, including
type and level.
switch <on|off>
As long as there is one active IPSec rule,
all packets go into the IPSec process to
check against the SPD. When this switch
is turned on, packets are not be put
through the IPSec process, even if there
are active IPSec rules.
timer
Table 67 IP commands
Command Description