Configuration manual

288 Appendix G Command Interpreter
NN47923-501
rmAddrType <0:single |
1:range |
2:subnet>
Sets the remote address type.
rmAddrStart <IP>
Sets the remote starting IP address.
rmAddrEndMask <IP>
Sets the remote ending IP address or
subnet mask.
rmPortStart <port>
Sets the remote starting port number.
rmPortEnd <port>
Sets the remote ending port number.
btNatActive <Yes | No>
Turns branch tunnel NAT address
mapping on or off.
btNatType <0:single |
1:range |
2:all>
Sets the type of NAT address mapping.
btNatAddrStart <IP address>
Sets the branch tunnel NAT starting IP
address.
btNatArEnd <IP address>
Sets the branch tunnel NAT ending IP
address or subnet mask.
swSkipOverlapIP <on|off>
Turn this option on to have the device
allow rules with overlapping source and
destination IP addresses.
adjTcpMss <off|auto|user
defined value>
Sets the adjust TCP Maximum Segment
Size.
contivityDial
Initiates the Contivity Client VPN
connection.
contivityDrop
Ends the Contivity Client VPN
connection.
contivityState
Displays information about the Contivity
Client VPN connection.
contivitySplit
contivityTimecnt <0~65535>
Sets the Contivity Client keep-alive
interval (in seconds).
exemptHost
Uses the exemptHost commands to
configure specific IP addresses that are
not to be part of a VPN tunnel.
display
Displays the exempt host settings.
load <index>
Loads an exempt host.
active <Yes|No>
Enables or disables an exempt host.
Table 68 IPSec commands
Command Description