Configuration manual

290 Appendix G Command Interpreter
NN47923-501
encr <128AES_SHA1 |
3DES_SHA1 |
3DES_MD5 |
DES_SHA1 |
DES_MD5 |
AH_SHA1 |
AH_MD5> <on |
off>
Enables or disables the specified
encryption algorithm.
DHG <DES_DH1 |
3DES_DH2 |
128AES_DH5 >
<on | off>
Enables or disables the specified
Diffie-Hellman encryption level.
aci static <on |
off>
Enables or disables the Use Static
Address option.
ipPool <index>
Select which IP pool, index is based on 1,
and inactive IP pool cannot be selected.
ipPool load <index>
Before you configure an IP pool for client
termination, you must load the specified
IP pool. Currently 3 IP pools are
supported, so the valid index is: 1~3
save
After changing the IP pool configuration,
use the save command to save the
modification to the ROM.
active
Enables or disables the loaded IP pool.
poolName
Sets the IP pool’s name.
startAddr
Sets the IP pool’s starting IP address.
subnet
Sets the IP pool’s subnet.
size
Sets the number of IP addresses in the IP
pool.
status
Displays the current runtime IP pool
status of Client Termination.
natt active <yes |
no>
Enables or disables NAT Traversal.
portSwitch
<enable |
disable>
Enables or disables Client IKE Source
Port Switching.
portNum
Sets the NAT Traversal UDP port, valid
UDP port: 1025 ~ 65535.
failover <1 | 2 | 3> <IP>
Sets the client failover IP address.
Table 68 IPSec commands
Command Description