Configuration manual

292 Appendix G Command Interpreter
NN47923-501
WAN Commands
The following chart lists and describes the wan commands. Each of these
commands must be preceded by wan when you use them.
anpr <on | off>
Enables or disables the requirement of a
alpha-numeric password.
age <days>
Sets the maximum password age after
which the login password expires, valid
value: 0~180 days, and 0 means no
expiration.
minLen
Sets the minimum password length.
Table 69 WAN Commands
Command Description
wan
adsl bert Displays ADSL ber.
cellcnt Displays the ADSL cell counter.
chandata Displays the ADSL operational mode
(standard) and ADSL channel data, line rate.
close Closes the ADSL line.
defbitmap Displays ADSL defect bitmap status.
dyinggasp Sends ADSL dyinggasp.
linedata far Shows ADSL far end noise margin and carrier
load information.
near Shows ADSL near end noise margin and
carrier load information.
open Opens the ADSL line.
opencmd Opens ADSL line with a specific standard.
opmode Shows the ADSL operational mode
(standard).
perfdata Shows performance information such as the
CRC,FEC, error seconds.
Table 68 IPSec commands
Command Description