Configuration manual

Chapter 3 WAN and Dial Backup Setup 71
Nortel Business Secure Router 252 Configuration — Advanced
Remote node filter
Move the cursor to the field Edit Filter Sets in menu 11.2, and then press
[SPACE BAR] to set the value to Yes. Press [ENTER] to open
Menu 11.2.4 -
Remote Node Filter.
Use menu 11.2.4 to specify the filter sets to apply to the incoming and outgoing
traffic between this remote node and the Business Secure Router to prevent
certain packets from triggering calls. You can specify up to four filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces
are accepted in this field. Refer to Chapter 11, “Filter configuration,” on page 133
for more information about defining the filters.
Figure 16 Menu 11.2.4: dial backup remote node filter
Menu 11.2.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: