User's Manual

Installation and configuration 105
Before you begin
Before installing the IP Phone 2004, complete the following pre-installation
checklist:
• Ensure one IP Phone 2004 boxed package exists for each IP Phone
2004 you install. For a list of IP Phone 2004 package components, see
Table 13 "Package components" (page 103).
•
Ensure one Software License exists for each IP Phone 2004 you
install.
• Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
•
If an AC power adapter is required, ensure you use the correct AC
power transformer. The voltage rating of the transformer must match
the wall outlet voltage. See Table 14 "IP Phone 2004 component list"
(page 103).
•
Ensure the latest IP Phone firmware is deployed to the IP
telephony node. For more information, see IP Line Fundamentals
(NN43100-500).
First-time installation
You must first install an IP telephony node with the Communication
Server. For information about installing an IP telephony node, see IP
Line Fundamentals (NN43100-500) or Signaling Server Installation and
Commissioning (NN43001-312).
CAUTION
Do not plug your IP Phone 2004 into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 2004
Use Procedure 18 “Configuring the IP Phone 2004” (page 105) to
configure the IP Phone 2004 for the first time.
Procedure 18
Configuring the IP Phone 2004
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Reference-Administration (NN43001-611).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.