User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

131

132

133

134

135

136

137

138

139

140

IP Phone KEM startup initialization 135

Procedure 26

Connecting the IP Phone KEM to an IP Phone 2002 or IP Phone 2004

Step Action

1 Remove the IP Phone from the stand by pressing the IP Phone

tilt handle, and pulling the IP Phone away from the stand.

For the IP Phone 2004, you can also adjust the stand angle to

maximum, instead of removing the stand.

2 Place the connecting arm of the IP Phone KEM behind the IP

Phone and align the IP Phone KEM connection plug to the AEM

port on the back of the IP Phone.

The IP Phones 2002 with the product codes: NTDU76AB34,

NTDU76BB34, NTDU76AB70, and NTDU76BB70 have shorter

connector pins than the other IP Phone 2002. Therefore, the

ribbon cable connector of the IP Phone KEM must be detached

from the retaining clip and pressed manually into the header

connector before attaching the IP Phone KEM.

3 Press the IP Phone KEM and IP Phone firmly together until the

IP Phone KEM locks into place.

4 If connecting a second IP Phone KEM, repeat steps 1 to 3.

The second IP Phone KEM is attached to the right side of the

first IP Phone KEM.

5 Attach the IP Phone stand and the IP Phone KEM stand, if

removed. Adjust each IP Phone KEM stand to the same angle

as the IP Phone.

The IP Phone KEM powers up.

The IP Phone KEM uses the electrical connection of the IP

Phone 2002 or IP Phone 2004 for power. It does not have its

own power source.

--End--

IP Phone KEM startup initialization

Once the IP Phone KEM has been installed and powered up on your IP

Phone 2002 or IP Phone 2004, the IP Phone KEM initializes (see Table 18

"Startup initialization process for the IP Phone KEM" (page 136)).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009