User's Manual

140 Nortel IP Audio Conference Phone 2033
This section contains the following procedures:
•
Procedure 27 “Configuring the IP Audio Conference Phone 2033”
(page 152)
•
Procedure 28 “Installing the IP Audio Conference Phone 2033 using
manual configuration” (page 156)
• Procedure 29 “Installing an IP Audio Conference Phone 2033 using
DHCP” (page 161)
•
Procedure 30 “Enable Full Duplex mode” (page 165)
•
Procedure 31 “Checking Ethernet Statistics” (page 166)
• Procedure 32 “Changing the TN of an existing IP Audio Conference
Phone 2033” (page 167)
•
Procedure 33 “Replacing an IP Audio Conference Phone 2033” (page
168)
•
Procedure 34 “Removing an IP Audio Conference Phone 2033 from
service” (page 168)
After you install and configure an IP Phone, if power to the phone is
interrupted, you need not re-enter the IP parameters, node number,
Terminal Number (TN), or reacquisition of firmware.
Description
The IP Audio Conference Phone 2033 uses the customer IP data network
to communicate with the Communication Server 1000 (CS 1000). The
IP Audio Conference Phone 2033 translates voice into data packets for
transport using Internet Protocol. Use a Dynamic Host Configuration
Protocol (DHCP) server to provide information that you can use for the IP
Audio Conference Phone 2033 network and CS 1000 connections.
Figure 13 "IP Audio Conference Phone 2033" (page 141) shows the IP
Audio Conference Phone 2033.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.