User's Manual

Installation and configuration 153

3 Connect one end of the CAT5 Ethernet cable to the network

interface located on the back of the Power over Ethernet (PoE)

module. See Figure 17 "POE module" (page 153). Plug the

other end of the CAT5 Ethernet cable into your IP network

interface.

4 Connect the CAT5 Ethernet cable attached to the PoE module

to the IP Phone. Thread the CAT5 Ethernet cable through the

channel on the bottom of the IP Phone and plug it into the PoE

module port on the IP Phone.

The PoE module port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation. The PC Port

does not support Auto-MDIX.

5 Connect the AC power adapter (optional) to the power supply

port located on the back of the PoE module, Leave the AC

power adapter unplugged from the power outlet. Thread the

cord through the channel on the bottom of the PoE module then

plug the other end into the AC power source. Ensure you use

the correct AC power transformer. The voltage rating of the

transformer must match the wall outlet voltage. See Table 21

"Components list for US, CA, CALA, AP, and GC" (page 149) or

Table 22 "Components list for EMEA" (page 150).

Figure 17 "POE module" (page 153) shows the Power over

Ethernet (PoE) module.

Figure 17

POE module

Red LEDs on the IP Audio Conference Phone 2033 indicate

power. Messages indicating system start up, such as Loading,

Initializing network, and Loading boot parameters appear after

a short delay.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009