User's Manual

Installation and configuration 159
Screen prompt
Description
Duplex (0-Auto, 1-Full) Default 1 (for Auto).
0 = Auto
1 = Full
Speed (0-10Mb, 1-100Mb) Network interface port speed.
0 = 10 BT
1= 100 BT
You are not prompted for Speed
if Duplex is set to 0 for Auto.
The IP Audio Conference Phone 2033 searches for the connect
server.
6 Enter the following information:
Screen prompt
Description
Password
IP Phone Installer Password.
You are not prompted to enter the IP
Phone Installer Password if it has not been
configured in your system.
Node The node ID.
TN The TN or VTN.
Select the Shift soft key labeled (>>) and press Clear to edit the
TN field. The IP Audio Conference Phone 2033 by default places
you in the units field of the TN. You can not use backspace to
move to the loop, shelf or card fields.
The IP Audio Conference Phone 2033 registers with the
Terminal Proxy Server (TPS) and, if needed, begins the firmware
download. This takes several minutes. When the download is
complete, the IP Audio Conference Phone 2033 resets.
The current system date and time appear on the top line of the
display when the configuration is complete. Self-labeling keys
also appear.
7 Check for a dial tone and the correct DN above the display.
8 (Optional) Customize the soft keys as required. For more
information, see
Software Input Output Reference-Administration
(NN43001-611) and IP Phone Audio Conference Phone 2033
User Guide (NN43111-100).
--End--
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.