User's Manual

172 Nortel IP Phone 2007

This section contains the following procedures:

•

Procedure 36 “Configuring the IP Phone 2007” (page 186).

• Procedure 37 “Installing the IP Phone 2007” (page 190).

•

Procedure 38 “Enabling Full Duplex mode” (page 199).

• Procedure 39 “Checking Ethernet Statistics” (page 200).

• Procedure 40 “Changing the TN of an existing IP Phone 2007” (page

201).

•

Procedure 41 “Replacing an IP Phone 2007” (page 202).

•

Procedure 42 “Removing an IP Phone 2007 from service” (page 202).

After you install and configure an IP Phone, if power to the phone is

interrupted, you need not re-enter the IP parameters, node number,

Terminal Number (TN), or reacquisition of firmware.

Description

The IP Phone 2007 uses the customer IP data network to communicate

with the Communication Server 1000 (CS 1000). The IP Phone 2007

translates voice into data packets for transport using Internet Protocol.

Use a Dynamic Host Configuration Protocol (DHCP) server to provide

information that you can use for the IP Phone 2007 network and CS 1000

connections.

Figure 19 "IP Phone 2007" (page 172) shows the IP Phone 2007.

Figure 19

IP Phone 2007

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009