User's Manual

Installation and configuration 189
See Table 31 "IP Phone 2007 IP parameters" (page 189) for a summary
of the IP parameters and how they are obtained.
Table 31
IP Phone 2007 IP parameters
Parameter Method of Acquisition
VLAN ID Manually entered or automatically obtained through DHCP
LLDP.
IP Address Manually entered or automatically retrieved through Partial
or Full DHCP.
Net Mask Manually entered or automatically retrieved through Partial
or Full DHCP.
Default Gateway Address Manually entered or automatically retrieved through Partial
or Full DHCP.
Connect Server (IP address, port,
action and retry count—primary and
secondary)
Manually entered or automatically retrieved through Partial
or Full DHCP.
User ID (Node ID, Node Password
and TN)
Manually entered for first-time configuration. Retrieved
from local storage on subsequent power cycles.
Installing the IP Phone 2007
To install the IP Phone 2007, use Procedure 37 “Installing the IP Phone
2007” (page 190).
ATTENTION
Timing information
There are only four seconds between plugging in the IP Phone 2007 power
adapter and the appearance of Nortel on the display. When Nortel appears in
the middle of the screen, you have 1 second to respond by pressing 0, 0, 7, *.
If you miss the 1-second response time, the IP Phone 2007 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the network diagnostic utilities to access
the IP Phone settings. See “IP Phone diagnostic utilities” (page 493).
You can press the Apply&Reset soft key at any time to apply the current
configuration and reset the phone. You can press the Exit soft key to
exit the menu without saving any changes and return to the Network
Configuration menu.
When the Network Configuration menu opens, Enable 802.1x Auth.
(EAP) is the first option in the list.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.