User's Manual

Redeploying an IP Phone [phone]
To enable GARP Protection during configuration, see Procedure 37
“Installing the IP Phone 2007” (page 190).
Extensible Authentication Protocol
Extensible Authentication Protocol (EAP) is a general protocol that fulfills
the protocol requirements defined by 802.1x. For further information about
802.1x, see “802.1x Port-based network access control” (page 479).
Redeploying an IP Phone 2007
You can redeploy an existing, previously-configured IP Phone 2007 on
the same system. For example, the IP Phone 2007 can be assigned to
a new user (new TN) or to an existing user who moved to a new subnet
by changing the TN of the IP Phone 2007. For further information, see
Converging the Data Network with VoIP Fundamentals (NN43001-260).
Procedure 40
Changing the TN of an existing IP Phone 2007
Step Action
1 Repower the IP Phone 2007.
During the reboot sequence of a previously configured IP
Phone, the IP Phone 2007 displays the existing node number
for approximately five seconds.
2 If the node password is enabled and NULL, choose one of the
following:
a Disable the password.
b Set the password as non-NULL.
3 Press OK when the node number displays.
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen, and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference—Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.