User's Manual

202 Nortel IP Phone 2007

6 Enter the new TN.

--End--

Replacing an IP Phone 2007

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

2007 that currently uses the TN.

Procedure 41

Replacing an IP Phone 2007

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 2007 that you want to replace.

3 Follow Procedure 36 “Configuring the IP Phone 2007” (page

186) and “Installing the IP Phone 2007” (page 189) to install and

configure the IP Phone 2007.

Enter the same TN and Node Number as the IP Phone 2007 you

replaced. The system associates the new IP Phone 2007 with

the existing TN.

--End--

Removing an IP Phone 2007 from service

Procedure 42

Removing an IP Phone 2007 from service

Step Action

1 Disconnect the IP Phone 2007 from the network or turn the

power off.

The service to the PC is disconnected as well if the PC connects

to the IP Phone 2007.

If the IP Phone 2007 was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009