User's Manual

304 Nortel IP Phone 1110
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 1110
• “Before you begin” (page 304)
• “First-time installation” (page 304)
• “Configuring the IP Phone 1110” (page 305)
•
“Startup sequence” (page 309)
• “Installing the IP Phone 1110” (page 310)
Before you begin
Before installing the IP Phone 1110, complete the following pre-installation
checklist
•
Ensure one IP Phone 1110 boxed package exists for each IP Phone
1110 you install. For a list of IP Phone 1110 package components, see
Table 44 "Package components" (page 302).
• Ensure one Software License exists for each IP Phone 1110 you
install.
• Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
•
If an AC power adapter is required, ensure the approved Nortel AC
adapter (model number N0089601) is used. See Table 45 "IP Phone
1110 components list" (page 303).
•
Ensure the latest IP Phone firmware is deployed to the IP
telephony node. For more information, see IP Line Fundamentals
(NN43100-500).
First-time installation
You must first install an IP telephony node with the Communication
Server. For information about installing an IP telephony node, see IP
Line Fundamentals (NN43100-500) or Signaling Server Installation and
Commissioning (NN43001-312).
CAUTION
Do not plug your IP Phone 1110 into an ISDN connection.
Severe damage can result.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.