User's Manual

Installation and configuration 305

Conﬁguring the IP Phone 1110

You must configure the IP Phone 1110 before you can use it. Use the

following procedure to configure the IP Phone 1110 for the first time.

Procedure 75

Conﬁguring the IP Phone 1110

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

For more information about configuring a virtual loop, see IP

Line Fundamentals (NN43100-500) and Software Input Output

Reference-Administration (NN43001-611).

2 Configure the IP Phone 1110 on the Call Server using LD 11. At

the prompt, enter the following

REQ:new

TYPE: 1110

For more information about configuring the IP Phone 1110 using

LD 11, see Software Input Output Reference-Administration

(NN43001-611).

CAUTION

The IP Phone 1110 is shipped with the stand and

stand cover locked in position. To avoid damaging

the IP Phone, press the wall-mount lever to release

the stand and pull it away from the base using the

tilt lever. See Figure 35 "Release the IP Phone 1110

from the stand" (page 306). To release the stand

cover, see and Figure 36 "Stand cover removed"

(page 306).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009