User's Manual

Installation and configuration 307

the cable, and then thread the adapter cord through the channels

in the stand.

WARNING

Use your IP Phone 1110 with the approved Nortel AC

adapter (model number N0089601).

The IP Phone 1110 supports both AC power and Power over

LAN options, including IEEE 802.3af Power Classification 2.

To use Power over Ethernet, where power is delivered over

the CAT5e cable, the LAN must support Power over Ethernet,

and an AC adapter is not required. To use local AC power, the

optional AC adapter can be ordered separately.

Figure 37 "IP Phone 1110 connections" (page 307) shows the IP

Phone 1110 connections.

Figure 37

IP Phone 1110 connections

5 Install the handset. Connect the end of the handset cable with

the short straight section into the handset. Connect the end of

the handset cable with the long straight section to the back of the

phone, using the RJ-9 handset jack. Form a small bend in the

cable, and then thread the handset cord through the channels in

the stand so that it exits behind the handset on the right side, in

the channel exit in the stand base. See Figure 38 "Cable routing

tracks" (page 308).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009