User's Manual

310 Nortel IP Phone 1110
• connecting to the Call Server
• obtaining a User ID
SeeTable 46 "IP Phone 1110 IP parameters" (page 310) for a summary of
the IP parameters and how they are obtained.
Table 46
IP Phone 1110 IP parameters
Parameter Method of acquisition
VLAN ID Manually entered or automatically obtained through DHCP
or LLDP.
IP Address Manually entered or automatically retrieved through partial
or full DHCP.
Net Mask Manually entered or automatically retrieved through partial
or full DHCP.
Default Gateway Address Manually entered or automatically retrieved through partial
or full DHCP.
Connect Server (IP address, port,
action, and retry count—primary and
secondary)
Manually entered or automatically retrieved through
User ID (node ID, node password and
TN)
Manually entered for first-time configuration. Retrieved
from local storage on subsequent power cycles.
Installing the IP Phone 1110
To install the IP Phone 1110, use the following procedures
•
Installing the IP Phone 1110 using manual configuration
• Installing the IP Phone 1110 using DHCP
Installing the IP Phone 1110 using manual configuration
ATTENTION
Timing information
There are approximately 30 seconds between plugging in the IP Phone 1110
power adapter and the appearance of the text Nortel. When you see the text
Nortel on the phone, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 1110 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the Local diagnostic utilities to access the
IP Phone settings. See “IP Phone diagnostic utilities” (page 493).
If you are prompted to enter a password when you double-press the
Services key, password protection is enabled.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.