User's Manual

312 Nortel IP Phone 1110
the IP Phone 1110 configuration to allow the following IP
address assignments
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
•
Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full
DHCP configuration. For more information about how to set up
DHCP servers for use with the IP Phones, see
Converging the
Data Network with VoIP Fundamentals (NN43001-260).
7 Enter the following information.
Screen prompt
Description
set IP a valid IP Phone 1110 IP address.
net msk a subnet mask.
def gw the default Gateway for the IP Phone 1110
on the LAN segment to which it connects.
8 Enter the information for the primary Connect Server (S1) and
the secondary Connect Server (S2).
ATTENTION
Not all parameters appear when you install the IP Phone for the first
time.
Screen prompt
Description
S1 IP The primary CS 1000 node IP
address for the IP Phone 1110.
S1 Port TPS Server 1 port number
Enter 4100.
S1 action
Choose one of the following:
• for TPS only, enter 1.
• for TPS and Secure
Multimedia Controller,
enter 6.
For more information about
Secure Multimedia Controller,
see Secure Multimedia
Controller Implementation
Guide (NN43001-325).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.