User's Manual

Removing an IP Phone 1110 from service 331

Replacing an IP Phone 1110

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

1110 that currently uses the TN.

Procedure 81

Replacing an IP Phone 1110

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 1110 that you want to replace.

3 Follow Procedure 75 “Configuring the IP Phone 1110 ” (page

305) and “Installing the IP Phone 1110” (page 310) to install and

configure the IP Phone 1110.

4 Enter the same TN and Node Number as the IP Phone 1110 you

replaced. The Call Server associates the new IP Phone 1110

with the existing TN.

--End--

Removing an IP Phone 1110 from service

Procedure 82

Removing an IP Phone 1110 from service

Step Action

1 Disconnect the IP Phone 1110 from the network or turn off the

power.

The service to the PC is disconnected as well if the PC connects

to the IP Phone 1110.

If the IP Phone 1110 was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 1110

TN: LLL S CC UU

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009