User's Manual

346 Nortel IP Phone 1120E
Before you begin
Before installing the IP Phone 1120E, complete the following
pre-installation checklist
• Ensure one IP Phone 1120E boxed package exists for each IP Phone
1120E you install. For a list of IP Phone 1120E package components,
see Table 50 "Package components" (page 344).
•
Ensure one Software License exists for each IP Phone 1120E you
install.
• Ensure the host Call Server is equipped with the a voice Gateway
Media Card and a Signaling Server with the Line TPS application.
•
If an AC power adapter is required, ensure the approved Nortel global
power supply (model number N0089601) is used. See Table 51 "IP
Phone 1120E components list" (page 344).
• Ensure the latest IP Phone firmware is deployed to the IP
telephony node. For more information, see IP Line Fundamentals
(NN43100-500).
First-time installation
You must first install an IP telephony node with the Communication
Server. For information about installing an IP telephony node, see IP
Line Fundamentals (NN43100-500) or Signaling Server Installation and
Commissioning (NN43001-312).
CAUTION
Damage to Equipment
Do not plug your IP Phone 1120E into an ISDN connection.
Severe damage can result. The IP Phone 1120E does not
support multiple devices connected through the PC Ethernet
port.
Configuring the IP Phone 1120E
You must configure the IP Phone 1120E before you can use it. Use
Procedure 83 “Configuring the IP Phone 1120E” (page 346) to configure
the IP Phone 1120E for the first time.
Procedure 83
Configuring the IP Phone 1120E
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Reference-Administration (NN43001-611).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.