User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

351

352

353

354

355

356

357

358

359

360

Installation and configuration 351

9 Wall-mount your phone (optional). Use Method A or Method B to

wall-mount the IP Phone. See Method A—using the mounting

holes on the bottom of the phone stand, or Method B—using the

traditional-style wall-mount box with a CAT5e connector and a 15

cm (6 inch) CAT5e cord (not provided).

• Method A: Press the wall-mount lever, and pull away from

the stand. Using the stand cover (see step 3), mark the

wall-mount holes by pressing the bottom of the stand cover

firmly against the wall in the location where you wish to install

the phone. Four small pins on the bottom of the stand cover

make the marks on the wall. Use the marks as a guideline to

install the wall-mount screws (not provided).

Install the screws so that they protrude 3 mm (1/8 inch) from

the wall, and then install the phone stand mounting holes

over the screw heads. You may need to remove the phone

from the wall to adjust the lower screws. When the lower

screws are snug, install the phone on the mounting screws,

and then tighten the top screws.

•

Method B: Attach the 15 cm (6 inch) CAT5e cable, position

the stand over the mounting rivets, and slide the phone down

the wall so that the rivets fit into the slots on the stand.

10 Replace the stand cover. Ensure that all cables are neatly routed

and press the stand cover into place until you hear a click.

11 If you wall-mount the phone, put it in the wall-mount position by

holding the tilt lever and press the phone towards the base until

the phone is parallel with the base. Release the tilt lever and

continue to push the phone towards the base until you hear a

click. Ensure the phone is securely locked in to position.

--End--

Startup sequence

When an IP Phone 1120E connects to the network, it must perform a

startup sequence. The elements of the startup sequence include

• obtaining VLAN ID (if supported by the network infrastructure)

• obtaining the IP parameters

• connecting to the Call Server

• obtaining a User ID

See Table 52 "IP Phone 1120E IP parameters" (page 352) for a summary

of the IP parameters and how they are obtained.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009