User's Manual

36 Nortel IP Phone 2001

Figure 3

IP Phone 2001 Ethernet network interface connections

6 Power the IP Phone 2001 using either the Power over Ethernet

or an AC power transformer (local power). If you are using local

power, plug the AC power transformer into the nearest power

outlet. Make sure you use the correct AC power transformer is

used. The voltage rating of the transformer must match the wall

outlet voltage. See Table 4 "IP Phone 2001 components list"

(page 33).

The IP Phone 2001 supports both AC power and Power over

LAN options, including IEEE 802.3af Power Classification 2.

To use Power over Ethernet, where power is delivered over

the CAT5e cable, the LAN must support Power over Ethernet,

and an AC adapter is not required. To use local AC power, the

optional AC adapter can be ordered separately.

--End--

When you complete the IP Phone connection, you must connect the phone

to the network. See Dynamic Host Configuration Protocol.

Conﬁguring the IP Phone 2001

Use Procedure 2 “Configuring the IP Phone 2001” (page 36) to configure

the IP Phone 2001 for the first time.

Procedure 2

Conﬁguring the IP Phone 2001

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009