User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

361

362

363

364

365

366

367

368

369

370

362 Nortel IP Phone 1120E

8 Press the Apply&Reset soft key to save the changes and to

restart the IP Phone. The firmware settings are read and are

applied to UPLINK and the PC Ethernet Port.

--End--

When the IP Phone 1120E restarts, the firmware reads the setting for Full

Duplex mode and sets both port 0, network interface port, and port 1, PC

interface port, accordingly.

Use Procedure 86 “Checking Ethernet Statistics” (page 362) to confirm

activation of Full Duplex mode.

Procedure 86

Checking Ethernet Statistics

Step Action

1 Double-press the Services key.

2 Press 2 to select Local Diagnostics, then press 3 to open the

Ethernet Statistics menu.

If Full Duplex mode is active, the following is displayed

• Link Status: UP

•

Duplex Mode: Full

•

Network Speed: 10 MB, 100 MB, or 1 G

•

Auto Sense/Negotiate

— Auto-Negotiate Capability: No

— Auto-Negotiate Completed: No

--End--

TFTP ﬁrmware upgrade

When you enter Cfg TFTP = 1 (for yes), and enter an IP address, the IP

Phone searches for an upgrade file on the TFTP Server.

Users of CS 1000 Release 4.5, or later do not need to enter a TFTP IP

address.

For further information about TFTP firmware upgrade, see “TFTP Server”

(page 557).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009