User's Manual

364 Nortel IP Phone 1120E
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference—Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 1120E
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
1120E that currently uses the TN.
Procedure 88
Replacing an IP Phone 1120E
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 1120E that you want to replace.
3 Follow Procedure 83 “Configuring the IP Phone 1120E” (page
346) and“Installing the IP Phone 1120E” (page 352) to install and
configure the IP Phone 1120E.
4 Enter the same TN and Node Number as the IP Phone 1120E
you replaced. The Call Server associates the new IP Phone
1120E with the existing TN.
--End--
Removing an IP Phone 1120E from service
Procedure 89
Removing an IP Phone 1120E from service
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.