User's Manual

Installation and configuration 381

Conﬁguring the IP Phone 1140E

You must configure the IP Phone 1140E before you can use it. Use

Procedure 90 “Configuring the IP Phone 1140E” (page 381) to configure

the IP Phone 1140E.

Procedure 90

Conﬁguring the IP Phone 1140E

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

For more information about configuring a virtual loop, see IP

Line Fundamentals (NN43100-500) and Software Input Output

Reference-Administration (NN43001-611).

2 Configure the IP Phone 1140E on the Call Server using LD 11.

At the prompt, enter the following

REQ: new

TYPE: 1140

For more information about configuring the IP Phone 1140E usi

ng LD 11, see Software Input Output Reference-Administration

(NN43001-611).

CAUTION

The IP Phone 1140E is shipped with the stand locked

in position. To avoid damaging the IP Phone, press

the wall-mount lever located under the Handsfree key

to release the stand and pull it away from the phone.

See Figure 47 "Release the IP Phone 1140E from the

stand" (page 381).

Figure 47

Release the IP Phone 1140E from the stand

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009