User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

381

382

383

384

385

386

387

388

389

390

Installation and configuration 385

CAUTION

Damage to Equipment

Do not plug any device into your IP Phone 1140E

Ethernet port other than an IEEE 802.3 Ethernet

network connection. The IP Phone 1140E does not

support multiple devices connected through the PC

Ethernet port.

9 Connect additional cables. If applicable, plug in optional USB

devices. Connect the Ethernet cable to the LAN Ethernet

connection. If you are using an AC power adapter, plug the

adapter into an AC outlet.

Complete steps 1 to 9, as needed, before wall-mounting the IP

Phone.

10 Wall-mount your phone (optional). Use Method A or Method B to

wall-mount the IP Phone. See Method A—using the mounting

holes on the bottom of the phone stand, or Method B—using the

traditional-style wall-mount box with a CAT5e connector and a 15

cm (6 inch) CAT5e cord (not provided).

• Method A: Press the wall-mount lever, and pull away from

the stand. Using the stand cover (see step 3), mark the

wall-mount holes by pressing the bottom of the stand cover

firmly against the wall in the location where you wish to install

the phone. Four small pins on the bottom of the stand cover

make the marks on the wall. Use the marks as a guideline to

install the wall-mount screws (not provided).

Install the screws so that they protrude 3 mm (1/8 inch) from

the wall, and then install the phone stand mounting holes

over the screw heads. You may need to remove the phone

from the wall to adjust the lower screws. When the lower

screws are snug, install the phone on the mounting screws,

and then tighten the top screws.

• Method B: Attach the 15 cm (6 inch) CAT5e cable, position

the stand over the mounting rivets, and slide the phone down

the wall so that the rivets fit into the slots on the stand.

11 Replace the stand cover. Ensure that all cables are neatly routed

and press the stand cover into place until you hear a click.

12 If you wall-mount the phone, put it in the wall-mount position by

holding the tilt lever and press the phone towards the base until

the phone is parallel with the base. Release the tilt lever and

continue to push the phone towards the base until you hear a

click. Ensure the phone is securely locked in to position.

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009