User's Manual

386 Nortel IP Phone 1140E
When you complete the IP Phone connection, the IP Phone follows a
startup sequence, as shown in “Startup sequence” (page 386).
Startup sequence
When an IP Phone 1140E connects to the network, it must perform a
startup sequence. The elements of the startup sequence include
•
obtaining VLAN ID (if supported by the network infrastructure)
•
obtaining the IP parameters
• connecting to the Call Server
• obtaining a User ID
See Table 58 "IP Phone 1140E IP parameters" (page 386) for a summary
of the IP parameters and how they are obtained.
Table 58
IP Phone 1140E IP parameters
Parameter Method of acquisition
VLAN ID Manually entered or automatically obtained through DHCP
or LLDP.
IP Address Manually entered or automatically retrieved through partial
or full DHCP.
Net Mask Manually entered or automatically retrieved through partial
or full DHCP.
Default Gateway Address Manually entered or automatically retrieved through partial
or full DHCP.
Connect Server (IP address, port,
action, and retry count—primary and
secondary)
Manually entered or automatically retrieved through
User ID (node ID, node password and
TN)
Manually entered for first-time configuration. Retrieved
from local storage on subsequent power cycles.
Installing the IP Phone 1140E
To install the IP Phone 1140E, use Procedure 91 “Installing the IP Phone
1140E” (page 387).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.