User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

381

382

383

384

385

386

387

388

389

390

Installation and configuration 387

ATTENTION

Timing information

There are approximately 45 second(s) between plugging in the IP Phone 1140E

power adapter and the appearance of the text Nortel. When you see the text

Nortel on the phone, you have 1 second to respond by pressing the four soft

keys at the bottom of the display in sequence from left to right, one at a time. If

you miss the 1-second response time, the IP Phone 1140E attempts to locate

the connect server. You can begin the power-up sequence again, or you can

double-press the Services key to open the Local diagnostic utilities to access the

IP Phone settings. See “IP Phone diagnostic utilities” (page 493).

If you are prompted to enter a password when you double-press the Services

key, password protection is enabled. For more information about password

protection, see “Local Tools menu” (page 483).

ATTENTION

When you install the IP Phone for the first time the first prompt that appears is

the DCHP? [0-N, 1-Y]. Not all of the listed screen prompts appear on the phone

display during the first time installation of the phone.

Procedure 91

Installing the IP Phone 1140E

Step Action

1 When the Nortel logo appears in the middle of the display,

immediately press the four soft keys at the bottom of the display

in sequence from left to right. The 3. Network Configuration

menu opens.

You can press the Apply&Reset soft key to save the following

settings and to reset the IP Phone. You can press the Exit soft

key exit the menu to exit the menu without saving any changes

and return to the 3. Network Configuration menu.

When the 3. Network Configuration menu opens, the Enable

802.1x (EAP) check box is highlighted.

2 Press the Enter key to switch this item on and off. A check mark

appears to indicate the item is active.

If 802.1x Authentication is enabled, press the Enter key to start

the edit mode. Use the dialpad to fill in the following information

• Device ID

•

Password

• Retype password

For further information about 802.1x Authentication, see “802.1x

Port-based network access control” (page 479).

If you do not enable 802.1x Authentication, you are not prompted

to enter Device ID and Password.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009