User's Manual

Removing an IP Phone 1140E from service 399

Replacing an IP Phone 1140E

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

1140E that currently uses the TN.

Procedure 95

Replacing an IP Phone 1140E

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 1140E that you want to replace.

3 Follow Procedure 90 “Configuring the IP Phone 1140E” (page

381) and “Installing the IP Phone 1140E” (page 386) to install

and configure the IP Phone 1140E.

4 Enter the same TN and Node Number as the IP Phone 1140E

you replaced. The Call Server associates the new IP Phone

1140E with the existing TN.

--End--

Removing an IP Phone 1140E from service

Procedure 96

Removing an IP Phone 1140E from service

Step Action

1 Disconnect the IP Phone 1140E from the network or turn the

power off.

The service to the PC is disconnected as well if the PC connects

to the IP Phone 1140E.

If the IP Phone 1140E was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 1140

TN: LLL S CC UU

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009