User's Manual

402 Nortel IP Phone 1150E

This section contains the following procedures

•

Procedure 97 “Configuring an IP Phone 1150E” (page 421).

• Procedure 98 “Installing the IP Phone 1150E ” (page 427).

•

Procedure 99 “Enabling Full Duplex mode” (page 436).

• Procedure 100 “Checking Ethernet Statistics” (page 436).

• Procedure 101 “Changing the TN of an existing IP Phone 1150E”

(page 438).

•

Procedure 102 “Replacing an IP Phone 1150E” (page 439).

•

Procedure 103 “Removing an IP Phone 1150E from service” (page

439).

After you install and configure an IP Phone, if power to the phone is

interrupted, you need not re-enter the IP parameters, node number,

Terminal Number (TN), or reacquisition of firmware.

Description

The IP Phone 1150E uses the customer IP data network to communicate

with the Communication Server 1000 (CS 1000) . The IP Phone 1150E

translates voice into data packets for transport using Internet Protocol.

Use a Dynamic Host Configuration Protocol (DHCP) server to provide

information that you can use for the IP Phone 1150E network and CS 1000

connections.

The IP Phone 1150E is configured for either an Agent, or a Supervisor.

The IP Phone 1150E is shipped with Agent key configuration but can be

modified to support Supervisor key configuration by replacing the key

caps. Remove the key caps using the Key Cap removal tool (product

number NTNM19AA). For information about IP Phone 1150E components,

see “Package components” (page 418).

Figure 51 "IP Phone 1150E default Agent key configuration" (page

403) shows the IP Phone 1150E default Agent key configuration.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009