User's Manual

Installation and configuration 421

Conﬁguring the IP Phone 1150E

You must configure the IP Phone 1150E before you can use it. Use

Procedure 97 “Configuring an IP Phone 1150E” (page 421) to configure

the IP Phone 1150E.

Procedure 97

Conﬁguring an IP Phone 1150E

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

For more information about configuring a virtual loop, see IP

Line Fundamentals (NN43100-500) and Software Input Output

Reference-Administration (NN43001-611).

2 Configure the IP Phone 1150E on the Call Server using LD 11.

At the prompt, enter the following:

REQ: new

TYPE: 1150

For more information about configuring the IP Phone 1150E usi

ng LD 11, see Software Input Output Reference-Administration

(NN43001-611).

CAUTION

The IP Phone 1150E is shipped with the stand

locked in position. To avoid damaging the IP Phone,

press the wall-mount lever located under the base to

release the stand and pull it away from the phone.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009