User's Manual

Removing an IP Phone 1150E from service 439

Replacing an IP Phone 1150E

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

1150E that currently uses the TN.

Procedure 102

Replacing an IP Phone 1150E

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 1150E that you want to replace.

3 Follow Procedure 97 “Configuring an IP Phone 1150E” (page

421) and “Installing the IP Phone 1150E” (page 426) to install

and configure the IP Phone 1150E.

4 Enter the same TN and Node Number as the IP Phone 1150E

you replaced. The system associates the new IP Phone 1150E

with the existing TN.

--End--

Removing an IP Phone 1150E from service

Procedure 103

Removing an IP Phone 1150E from service

Step Action

1 Disconnect the IP Phone 1150E from the network or turn the

power off.

The service to the PC is disconnected as well if the PC connects

to the IP Phone 1150E.

If the IP Phone 1150E was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 1150

TN: LLL S CC UU

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009