User's Manual

444 Expansion Module for IP Phone 1100 Series
Table 70
LD 11 - Configure the Expansion Module (cont’d.)
Prompt Response Description
... ... ...
KEM (0) - 3/<CR> Number of attached Expansion Modules (0). Up to three
Expansion Modules are supported.
... ... ...
CLS KEM3 KEM3 CLS must be defined
KEY 0 - <see text>/<C
R>
Key number range expanded to support number of
Expansion Modules specified by KEM prompt. The range
on the IP Phone is as follows:
KEM value:
0
1
2
3
KEY range:
0to31
32 to 49
50 to 67
68 to 85
PAGEOFST <Page> <KeyOff-
set> / <CR>
PAGEOFST is prompted if one Expansion Modules is
specified at the KEM prompt and <CR> is entered at the
KEY prompt. This prompt enables you to enter a Page
number of 0, or 1, and a Key Offset number from 0 to 17.
Once entered, the KEY is prompted with the appropriate
KEY value filled in. <CR> ends the input.
KEY <key> <keys conf data>/
<CR>
<key> is the key number for the Page + Key Offset
entered at PAGEOFST. Enter the key configuration <CR>
or just <CR>.
KEMOFST <KEM> <Key-Off-
set> / <CR>
KEMOFST is prompted if two or three Expansion Modules
are specified at the KEM prompt and <CR> is entered for
KEY prompt.
This prompt enables you to enter a KEM number of 1,
2, or 3 and a KEY Offset number from 0 to 17. Once
entered, the KEY prompt is prompted with the appropriate
KEY value filled in. <CR> ends the input.
KEY <key> <keys conf data>/
<CR>
<key> is the key number for the KEM + Key Offset
entered at KEYOFST. Enter the key configuration <CR>
or just <CR>.
Installation
The Expansion Module mounts on the right side of the IP Phone. The
Expansion Module snaps into the receptacle on the back of the IP Phone
using the desk-mount bracket and structural baseplate supplied with the
Expansion Module.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.