User's Manual

Installation 445

The Expansion Module connects to the IP Phone using the Accessory

Expansion Module (AEM) port on the IP Phone.

Use Procedure 104 “Connecting the Expansion Module to the IP Phone”

(page 445) to connect the Expansion Module for IP Phone 1100 Series

to the IP Phone.

CAUTION

Damage to Equipment

To avoid damaging the equipment, remove the power (PoE

cable, or local power) from the IP Phone before connecting the

Expansion Module.

CAUTION

The Expansion Module is shipped with the base locked in

position. To avoid damaging the Expansion Module, press

the wall-mount lever, located on the base at the front of the

Expansion Module.

Procedure 104

Connecting the Expansion Module to the IP Phone

Step Action

1 Press the tilt lever to adjust the stand angle on the IP Phone.

See Figure 59 "Wall-mount lever" (page 445). You can adjust

the stand angle to maximum, instead of removing the stand. See

Figure 60 "Adjusting the stand angle on the IP Phone" (page

446).

Figure 59

Wall-mount lever

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009