User's Manual

Installation 447

Figure 61

Connecting the Expansion Module

4 If connecting a second, or a third Expansion Module, repeat

steps 2 to 4.

The second Expansion Module is attached to the right side of the

first Expansion Module. The third Expansion Module is attached

to the right side of the second Expansion Module.

5 Adjust the height of the IP Phone tilt adjustment to a comfortable

viewing angle. Then adjust each of the Expansion Module

footstands so they are flush to the desk surface. Turn the wheel

on the back right side of the Expansion Module to the right (if

viewed from the front) to tighten the Expansion Module.

CAUTION

Do not over tighten the wheel on the Expansion

Module.

6 Connect power to the IP Phone. The Expansion Module powers

up.

The Expansion Module uses the electrical connection of the IP

Phone for power. It does not have its own power source.

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009