User's Manual

496 IP Phone diagnostic utilities
Network QoS Process
In Remote Mode, the system administrator can view QoS statistics (for
example, packets sent, packets received, packet loss, jitter average and
jitter maximum, and round trip delay).
Supplicant Status
The system administrator uses this option to determine whether 802.1x is
enabled or disabled 802.1x.
Authentication State
The system administrator uses this option to determine whether the IP
Phone is currently authenticated with the 802.1x system. The following
are valid state values
•
LogOff
• Disconnected
•
Connected
•
Acquired
•
Authorizing
• Held
•
Authorized
• Dbl Authd
DeviceID
The system administrator uses this option to check the user name
configured for the device that is sent to the switch for authentication. This
should match the corresponding entry in the RADIUS Server.
Authenticator ID
The system administrator uses this option to check the MAC address of
the Authenticator (switch).
Accessing Network Diagnostic utilities from the IP Phone
Local diagnostics are available from the IP Phone for either Local or
Remote mode.
Diagnostics prompts are presented in English.
Local Mode
When the IP Phone is not registered with the signaling server, the
Network Diagnostic Tools menu is available from the IP Phone in Local
Mode (see Table 80 "Network Diagnostic Utilities availability" (page 494)).
This menu is controlled by the firmware on the IP phone.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.